Tag: 3d printing

  • Better Filament Dryer

    —

    by

    iopadmin
    in

    The previous dryer only achieved a peak temperature of about 47C, which is much lower than the recommended 80C from 3devo. I made two upgrades: Wrapped the bucket in a moving blanket for insulation, and then because I was concerned about overheating, Connected a PID controller. I did not seriously try to run this at…

  • 3D Printer Filament Dryer

    —

    by

    iopadmin
    in

    I built a filament dehydrator following the basic plan on Taulman3D’s site, which I expect to need for both PETG and nylon prints. PLA prints have never been a problem for me here in the high desert. Taulman3D suggests using a 40 W or 60 W lightbulb as the heat source, and that the 40…